-18^%

WS2812 WS 2811 5050 RGB LED Lamp Panel Module 5V 8-Bit Rainbow LED

WS2812 WS 2811 5050 RGB LED Lamp Panel Module 5V 8-Bit Rainbow LED

Available:Out of Stock

Product SKU: KG542

Wishlist

₹ 170 ~~₹ 208~~

Pre-order

Specification

Description

8-bit 5050 RGB LED Light is a great collection of WS2812B RGB Addressable LED Modules in a straight PCB. WS2812B is an intelligent LED that includes the photodiode and an addressable controller chip both are available and integrated into a single 5050 Components package. The major advantages of these LEDs are that one can access each led individually and control the light as each led has a unique address. These small LEDs with merely a centimeter in diameter can be connected in a daisy chain manner and many numbers of LEDs can be connected.

This Straight LED PCB consists of 8 WS2812 LEDs. The pinout of this PCB is GND, VCC, Input, Output. The daisy chain connection will follow in a way that the Input of a strip will be the Output of the previous strip.

Technical Details

IC Chip: WS2812
Input Supply Voltage (VDC) : 4 ~ 7, 5V Recommended

Feature

Intelligent reverse connects protection, the power supply reverse connection does not damage the IC.
The control circuit and the LED share the only power source.
Control circuit and RGB chip are integrated into a package of 5050 components, forming a complete control of pixel point.
Each pixel of the three primary colors can achieve a 256 brightness display, completed 16777216 color full-color display, and scan frequency not less than 400Hz/s.
Cascading port transmission signal by a single line.
Any two points the distance more than 5m transmission signal without any increased circuit.
When the refresh rate is 30fps, cascade numbers are not less than1024 points.
Send data at speeds of 800Kbps.
The color of the light was highly consistent, cost-effective.
120 degrees viewing angle

Basic Troubleshooting

If the LED does not turn on:

Check the supply voltage
Check to see if the dies inside the clear epoxy case look black, it means the LED has been damaged.
Check if the data lines have been connected correctly and that the required signal and timing is present.