-37^%

DSO150 Portable Handheld Mini Digital Oscilloscope Kit with Housing Case Box

DSO138 2.4″ TFT Handheld Pocket-Size Digital Oscilloscope DIY Kit

DSO150 Portable Handheld Mini Digital Oscilloscope Kit with Housing Case Box

Available:Out of Stock

Product SKU: KG934

Wishlist

₹ 4,599 ~~₹ 7,359~~

Pre-order

Specification

Description

DSO150 Portable Handheld Mini Digital Oscilloscope Kit with Housing Case Box

This is a JYE Tech fully assembled tech DS0150 15001K DSO-Shell (DSO150) DIY digital oscilloscope kit. As we can see, an oscilloscope has a rarely high accuracy, which is unlike a multimeter but allows us to see the processes in the dynamics. Earlier oscilloscopes consisted of vacuum-tube which were then replaced by the transistor, but the result is still displayed on the CRT screen.

Eventually, they were replaced by their digital counterparts, smaller, lighter, and more convenient. The collecting is certainly easy and even a schoolboy can do it in his own hands. The most important thing you have to do is choose a decent DIY Digital Oscilloscope Kit.

Technical Details

Number of Channels: 1
Analog Bandwidth: 0 - 200KHz
Sensitivity: 5mV/Div - 20V/Div
Sensitivity Error: < 5%
Resolution: 12-bit
Input Impedance: 1M ohm
Maximum Input Voltage: 50Vpk
Coupling: DC, AC, GND
Max Real-Time Sampling Rate: 1Msps
Timebase: 10us/Div - 500s/Div
Record Length: 1024
Trigger Modes: Auto, Normal, Single
Trigger Types: Rising/falling edge
Trigger Position: 1/2 of buffer size fixed
Power Supply: 9V DC (Ensure exact 9V to avoid issues)
Supply Current: 120mA @ 9V
Display: 2.4-inch color TFT LCD (320 x 240 resolution)

Feature

Similar bandwidth to DSO138 with improved structure and operation
Display and MCU mounted on the same mainboard for better reliability
Separate analog board enhances separation between analog and digital circuits
Mainboard can serve as a general-purpose control board
Fully installed and factory-tested mainboard (except a few through-hole components)
DIY kit includes a full enclosure with flexible front panel modifications
Rotary encoder for quicker and easier parameter adjustments
Extended sensitivity: 5mV/div - 20V/div (higher than DSO138)
Runs on a 9V power supply (not included)
Supports 5.5mm/2.1mm DC plug and 2-pin connector for power input

Applications :

Signal analysis and waveform measurement
Circuit debugging and troubleshooting
Electronic testing and repair
Embedded system development
Educational and training purposes

Basic functions of buttons

V/DIV: Select the sensitivity or vertical position, and the selected parameters are highlighted.
SEC/DIV: Select the time base or horizontal position, and the selected parameters are highlighted.
TRIGGER: Select the trigger mode, trigger level, or trigger edge, and the selected parameters are highlighted
OK: Enter the HOLD state (freeze the waveform), and press again to exit the HOLD state (unfreeze the waveform).
ADJ: Adjust the selected (highlighted) parameters.
Edit switch: Set the edit to DC, AC, or GND, and when the switch is placed in the GND position, the output of the Yunbo device)

Calibration instructions

Pull out the voltage probe
Enter calibration mode
Adjust the voltage gear 5mV--20V (the order does not matter)
Switch the editing mode and repeat 3 operations until all three editing modes are calibrated
Exit the calibration mode (the calibration parameters will be saved when exiting, if you don't exit and turn it off directly, this calibration will be invalid)