Wow! I use this and the thermistor on KitsGuru that says 500c. And i print pei on a ender 3! With marlin changes that you can get right from the thermistor page when you order it! Hope this helps. Oh and i use dragonfly hotend.

Been working great for me. Heats up very quickly. Have not tested it's max temp yet but for a standard temp heater core it's great. Just make sure you run some autoPID cycles with it so it stops overshooting target temp by +50.

measured around 9.4 ohms.

The wiring is a bit short. I think it's only 1m. Would have like to have seen 1.5m at least.Other than that, works as advertised. No other complaints.

Much faster to heat up the hot end than the 40 watt element that was on the 3d printer. The diameter is correct, and the wiring is of ample gauge (aluminum btw) with the insulation being flexible and high quality.

Installed in my CR10S Pro V1. Works great and heats up fast.

My hotend heats from 0-265 is well under 2 minutes. Crazy fast. Nothing bad to say

Works perfectly as adverted

Heats nice and quick on my modded prusa 2.5, you have to add your connectors but that shouldn't be a problem if you have a printer