PT100-S Waterproof 320mm, 30mm Probe PTFE FTARP05 Stainless Steel Pole Probe Temperature Sensor
- Product SKU: KG084
Need Volume Discounts? Deals are specially designed for you. Click here
Need Customization? Provide us more details Click here
- Order within
DescriptionThe PTFE FTARP05 Stainless Steel Pole Probe Temperature Sensor has high quality and uses a closed stainless steel sleeve, much higher quality than the common heating tube on the market. PT100-S Waterproof Temperature Sensor is more durable and has better discrimination.
The PT100-S Waterproof 1m 30mm Probe PTFE FTARP05 Stainless Steel Pole Probe Temperature Sensor has a water-immersible probe suitable for precision air or liquid temperature measurements. You can immerse both the probe and the cable in the water for continuous operation. It also can be used with a thermal well.
- Temperature Range(Â°C) : -200 to 420
- Accuracy : ±(0.3°C+0.5%|t|)
- Response Time(s) : <0.5
- The Probe material: Stainless steel
- Probe diameter: 4mm
- Length of the probe (mm) : 30
- Cable Length (mm) : 320
- Model number: FTARP05 series
- Cabel material Silver plated copper (not insulated), PTFE Silver plated copper (Waterproof, insulated
- Mounting form Polish rod probe
- a- Datasheet
- 1 x PT100-S Waterproof 320mm, 30mm Probe PTFE FTARP05 Stainless Steel Pole Probe Temperature Sensor
Wow! I use this and the thermistor on KitsGuru that says 500c. And i print pei on a ender 3! With marlin changes that you can get right from the thermistor page when you order it! Hope this helps. Oh and i use dragonfly hotend.
Been working great for me. Heats up very quickly. Have not tested it's max temp yet but for a standard temp heater core it's great. Just make sure you run some autoPID cycles with it so it stops overshooting target temp by +50.
measured around 9.4 ohms.
The wiring is a bit short. I think it's only 1m. Would have like to have seen 1.5m at least.Other than that, works as advertised. No other complaints.
Much faster to heat up the hot end than the 40 watt element that was on the 3d printer. The diameter is correct, and the wiring is of ample gauge (aluminum btw) with the insulation being flexible and high quality.
Installed in my CR10S Pro V1. Works great and heats up fast.
My hotend heats from 0-265 is well under 2 minutes. Crazy fast. Nothing bad to say
Works perfectly as adverted
Heats nice and quick on my modded prusa 2.5, you have to add your connectors but that shouldn't be a problem if you have a printer